Menu
Marie-Lynn Richard
  • See me on Twitch
  • See me on Twitter
Marie-Lynn Richard

Building the EQKit Auto On Off Photocell Light Switch DIY Kit (Day 1)

Posted on May 22, 2020May 22, 2020 by Marie-Lynn Richard

Work is progressing on photoresistor switch by EQKit. #twitchstreamer pic.twitter.com/ZusemmdGzN

— Marie-Lynn Richard 🤖 (@mlrichard) May 23, 2020

Using photoresistor induction light intensity, built-in relay, direct control of the load
With a potentiometer sensitivity adjustment, by adjusting the potentiometer, set the start relay valve value, when the light on the threshold, relay module pull-in, dark at the threshold, the relay release, so pick up normally open with the public is the control of the switch during the day, pick up normally closed with the public is to control the switch in the evening.
Working voltage 12v. Output forms: direct connect AC 250V 10A or DC 30V 10A
Sesor Size : 60 x 20.5mm/ 2.4
Equipped with four fixed bolt hole, convenient installation. Small board PCB size: 5 cm x 2.6 cm

Watch Building the EQKit Auto On Off Photocell Light Switch DIY Kit (Day 1) from MLRichard on www.twitch.tv

Twitter

My Tweets
©2021 Marie-Lynn Richard | Powered by WordPress & Superb Themes